Technical parameters of the LWKW series

Working pressure: inlet B: from vacuum up to 350 bar.

Design: The main structural components are made of corrosion-resistant stainless steel. The sealing material is nitrile rubber (NBR), which can be designed according to customer needs.

Leakage rate:10-3mbar×1/s (10-4Pa×m3/s)

*This is the standard minimum leak rate, we can provide lower leakage rate devices on demand, depending on the detailed specifications (test method, test temperature and test pressure) provided by the customer and the quality of the samples provided by the customer (ie sealing surface) Surface treatment conditions, roughness and dimensions allow tolerances).

Test procedure: Screw the quick connector into the test piece with your fingers until the O-ring contacts the end face of the test piece, and the quick connector is connected.

Instructions:

1. Screw the LWKW series quick connector into the thread;

2. Gently tighten with your fingers to make the joint seal O-rings properly compressed;

3. The LWKW series quick connector can be connected to the test pressure;

4. After use, the test pressure should be cut off before the connector is screwed out.

Specification size (mm):

Media connector and swivel connector quick connector

LWKW series fast connector detail table

According to the metric ISO thread

According to the British tube thread

According to the tapered British pipe thread (BSPT thread)

NPT- thread

JEJ-J514JIC37